11/12/2022 0 Comments Wave soldering vs reflowAir can then be forced through the cylinder to get foam to rise out through the chimney. Once the cylinder has been well and truly submerged, a metal chimney can be fitted over the top of it. A plastic cylinder with tiny holes is submerged in the tank of flux. Foam flux, which is applied to the board from a tank of regular flux.Spray flux, which can be applied as a fine mist and followed up with a jet of compressed air to remove any excess.There are two different ways to apply flux, depending on the circumstances. Wave soldering vs reflow free#Flux helps ensure the areas of the board that need to be soldered are clean and free of oxidation. Once the board to be soldered has been checked for pad spacing and a layer of solder resist, it’s time to apply flux. Still, double-checking that a solder mask or solder resist layer is part of your PCB’s blueprint is always a good thing to do, and helps prevent unfortunate accidents. Solder resist: Having a layer of solder resist on the printed circuit board isn’t as much of an issue as it was in the past, as a solder resist layer is in the blueprint as standard practice.Short-circuiting of not only the two connected pads, but possibly the entire PCB, is the result. Pad spacing: If the pads that need to be soldered are too close together, liquid solder can flow between them.Inside the tank, the technician sets up a wave of solder, then passes each PCB through the tank, so the top of the wave of solder just makes contact with the bottom of the PCB.ĭesigners need to be aware of two major issues when it comes to designing printed circuit boards that are going to be wave soldered. So what’s in a wave solder machine, and how does the process work?Īt its core, a standard wave solder machine starts with one component: a heated tank of solder that is maintained at the required temperature for the specific soldering process that is taking place. The wave soldering process is effective for both the conventional through-hole method of PCB assembly and also the newer surface-mount method. Using a wave of solder as opposed to individual solder points produces solder joints that are mechanically and electrically reliable. The process gets its name from the wave of solder each board gets passed over. The wave soldering process allows manufacturers to quickly and reliably solder large printed circuit boards. Wave soldering is a type of soldering process used during the bulk manufacture of printed circuit boards, or PCB. Jump To: What is Wave Soldering? | Wave Soldering Defects and Remedies What Is Wave Soldering?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |